Voyager 1602g User Guide 97
User Specified Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed after the transmission of a particular character of scanned data. Scan the
Delay Length barcode below, then scan the number of 5ms delays from the
Programming Chart, beginning on page 225, then Save.
Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value for a
printable character to trigger the delay (see Lower ASCII Reference Table,page
217.
)
To remove this delay, scan the Delay Length barcode, and set the number of
delays to 0. Scan the Save barcode from the Programming Chart, beginning on
page 225.
Interfunction Delay
An interfunction delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each control character in the message string.
Scan the Interfunction Delay barcode below, then scan the number of 5ms delays,
and the Save barcode from the Programming Chart, beginning on page 225.
To remove this delay, scan the Interfunction Delay barcode, then set the number
of delays to 0. Scan the Save barcode from the Programming Chart, beginning on
page 225.
Character to Trigger Delay
Interfunction Delays
Prefix Scanned Data Suffix
1 2345STX HT CR LF
Interfunction Delay
To Next Page
Loading...
Need help?
General
Weight and Dimensions
