Honeywell Voyager 1602g - Chapter 4 - Input;Output Settings

50 Voyager 1602g User Guide
Note: When the scanner is in power down mode, press the scan button to power the unit
back up. There will be a set of power up beeps and a delay of up to a few seconds for
the radio to join. The scanner will then be ready to use.
Flexible Power Management
If you are experiencing network performance issues, and suspect the scanner is
interfering with other devices, you can turn down the power output of the scanner.
This reduces the range between the scanner and a host as shown in the following
illustration:
Scan one of the barcodes below to set the scanner’s power output to Full Power
(100%), Medium Power (35%), Medium Low Power (5%), or Low Power (1%).
Default = Full Power.
0 seconds
200 seconds
400 seconds
900 seconds
* 3600 seconds
7200 seconds
F
u
l
l
P
o
w
e
r
R
e
d
u
c
e
d
P
o
w
e
r
Scanner
802.11
LAN