28 Voyager 1602g User Guide
Wincor Nixdorf Beetle™ Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Wincor Nixdorf
Beetle terminal, then power cycle the host. This barcode sets the baud rate to
115200 bps and the data format to 8 data bits, no parity, 1 stop bit. This interface is
only appropriate for an Access Point. The following prefixes are programmed for
each symbology:
Wincor Nixdorf RS232 Mode A
Scan the following Plug and Play code to program the scanner for a Wincor Nixdorf
RS232 Mode A terminal, then power cycle the host. This barcode sets the baud rate
to 9600 bps and the data format to 8 data bits, odd parity, 1 stop bit. This interface
is only appropriate for an Access Point. The following prefixes are programmed for
each symbology:
Symbology Prefix Symbology Prefix
Aztec Code V Interleaved 2 of 5 I
Codabar N MaxiCode T
Code 93 L MicroPDF417 S
Code 128 K PDF417 Q
Data Matrix R QR Code U
EAN-8 B Straight 2 of 5 IATA H
EAN-13 A UPC-A A0
GS1 DataBar E UPC-E C
GS1-128 P All other barcodes M
Wincor Nixdorf Beetle Settings
Symbology Prefix Symbology Prefix
Code 128 K EAN-13 A
Code 93 L GS1-128 K
Codabar N Interleaved 2 of 5 I
UPC-A A0 Plessey O
UPC-E C Straight 2 of 5 IATA H
EAN-8 B GS1 DataBar E
All other barcodes M
Wincor Nixdorf RS232 Mode A
Settings
To Next Page
Loading...
