Voyager 1602g User Guide 1
GETTING STARTED
About This Manual
This User Guide provides installation and programming instructions for the Voy-
ager 1602g scanners. Product specifications, dimensions, warranty, and customer
support information are also included.
Note: The selections in this User Guide are dependent on the Voyager 1602g model you
have purchased. PDF and 2 dimensional barcodes can only be read by model
1602g2D and cannot be read by model 1602g1D.
Honeywell barcode scanners are factory programmed for the most common termi-
nal and communications settings. If you need to change these settings, program-
ming is accomplished by scanning the barcodes in this guide.
An asterisk (*) next to an option indicates the default setting.
Unpacking Your Device
After you open the shipping carton containing the product, take the following
steps:
• Check for damage during shipment. Report damage immediately to the carrier
who delivered the carton.
• Make sure the items in the carton match your order.
• Save the shipping container for later storage or shipping.
Charging the Scanner Battery
The scanner’s battery must be fully charged before the first use. It can be charged
using a power supply or by connecting the USB cable to a computer. Refer to About
the Battery on page 43 for further battery information.
To Next Page
Loading...
