Honeywell Voyager 1602g - Good Read Delay; User-Specified Good Read Delay; Manual Trigger Modes

74 Voyager 1602g User Guide
to an error. To change the number of error beeps, scan the barcode below and then
scan a digit (1-9) barcode and the Save barcode on the Programming Chart.
Default = 1.
Good Read Delay
This sets the minimum amount of time before the scanner can read another bar-
code. Default = 0 ms (No Delay).
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the barcode below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
Programming Chart, then scanning Save.
Manual Trigger Modes
When in manual trigger mode, the scanner scans until a barcode is read or until the
scan button is released. Two modes are available, Normal and Enhanced. Normal
mode offers good scan speed and the longest working ranges (depth of field).
Enhanced mode will give you the highest possible scan speed but slightly less
Number of Error Beeps/LED Flashes
* No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)
User-Specified Good Read Delay