Voyager 1602g User Guide 77
CodeGate
®
When CodeGate is On, the scan button is used to allow decoded data to be trans-
mitted to the host system. The scanner remains on, scanning and decoding bar-
codes, but the barcode data is not transmitted until the scan button is pressed.
When CodeGate is Off, barcode data is transmitted when it is decoded. Default =
CodeGate Off Out-of-Stand.
Mobile Phone Read Mode
When this mode is selected, your scanner is optimized to read barcodes from
mobile phone or other LED displays. However, the speed of scanning printed bar-
codes may be slightly lower when this mode is enabled.
Note: To turn off Mobile Phone Read Mode, scan the Manual Trigger Modes barcode.
Character Activation Mode
You may use a character sent from the host to trigger the scanner to begin scan-
ning. When the activation character is received, the scanner continues scanning
until either the Character Activation Timeout, the deactivation character is received
(see Deactivation Character), or a barcode is transmitted. Scan the following On
barcode to use character activation, then use Activation Character (following) to
select the character you will send from the host to start scanning. Default = Off.
* CodeGate Off
Out-of-Stand
Hand Held Scanning - Mobile
Phone
To Next Page
Loading...
