54 Voyager 1602g User Guide
Resetting the Factory Defaults:
All Application Work Groups
The following barcode defaults all of the work groups to the factory default set-
tings.
To see what the factory default settings are, refer to the table of Menu Commands,
beginning on page 182. The standard product default settings for each of the com-
mands are indicated by an asterisk (*).
Note: Scanning this barcode also causes both the scanner and the host to perform a reset
and become unlinked. You must relink (pair) the scanner to the host. Refer to
Bluetooth Settings, page 37 for additional information.
If your scanner is in multiple scanner mode, you will hear up to 30 seconds of beeping
while all scanners are relinked to the host and the settings are changed.
Reset the Custom Defaults: All Application Work Groups
If you want the custom default settings restored to all of the work groups, scan the
Custom Product Default Settings barcode below. (If there are no custom defaults,
it will reset the work groups to the factory defaults.) See Setting Custom Defaults
on page 7. for further information about custom defaults.
Note: Scanning this barcode also causes both the scanner and the host to perform a reset
and become unlinked. You must relink (pair) the scanner to the host. See Bluetooth
Settings, page 37 for additional information.
If your scanner is in multiple scanner mode, you will hear up to 30 seconds of beeping
while all scanners are relinked to the host and the settings are changed.
Factory Default Settings:
All Work Groups
PAPDFT&
Custom Default Settings:
All Work Groups
To Next Page
Loading...
Need help?
General
Weight and Dimensions
