Honeywell Voyager 1602g - Aimer Delay; User-Specified Aimer Delay

80 Voyager 1602g User Guide
Aimer Delay
The aimer delay allows a delay time for the operator to aim the scanner before the
barcode is read. Use these codes to set the time between when the scan button is
pressed and when the barcode is read. During the delay time, the aiming light will
appear, but the LEDs won’t turn on until the delay time is over. Default = Off.
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the barcode
below, then set the time-out by scanning digits (0 - 4,000 ms) from the
Programming Chart inside the back cover of this manual, then scan Save.
* Lights On
Lights Off
200 milliseconds
400 milliseconds
* Off (no delay)
Delay Duration