Voyager 1602g User Guide 55
Access Point Operations
The Voyager 1602g can pair with a Honeywell Access Point (AP01-010BT or AP01-
100BT), which provides 2-way communication between the scanner and host.
Linking the Scanner to an Access Point
Turn on the host computer (laptop/desktop). Plug the inter-
face cable into the Access Point first and then into the
appropriate port on the computer. The Page button lights
up when the connection to the host is made.
Scan the linking barcode on the top of the Access Point to
establish a connection between the Access Point and the
scanner. The scanner emits a short beep and flashes the
green LED to confirm a connection with the Access Point.
The Access Point’s Page button remains blue.
If the Access Point sounds 5 error tones followed by 3 beeps, it indicates that you
are attempting to link to the incorrect model Access Point. The Voyager 1602g
scanner can only link to an Access Point model AP01-010BT or AP01-100BT.
To Next Page
Loading...
