Honeywell Voyager 1602g - Function Code Transmit; Intercharacter, Interfunction, and Intermessage Delays; Intercharacter Delay

96 Voyager 1602g User Guide
Function Code Transmit
By default, all ASCII control characters are transmitted with barcode data. These
non-printable characters are translated into predefined key strokes, or CTRL+X
functions (see ASCII Conversion Chart (Code Page 1252), beginning on page 216).
If these key strokes interfere with your host’s software application, scan Disable to
keep these ASCII control characters from being transmitted. Default = Enable.
Note: You can also use a custom data format (see Data Format beginning on page 99) to
translate these characters into a more meaningful output.
Intercharacter, Interfunction, and Intermessage Delays
Some terminals drop information (characters) if data comes through too quickly.
Intercharacter, interfunction, and intermessage delays slow the transmission of
data, increasing data integrity.
Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each character of scanned data. Scan the
Intercharacter Delay barcode below, then scan the number of 5ms delays from the
Programming Chart, beginning on page 225, then Save.
To remove this delay, scan the Intercharacter Delay barcode, then set the number
of delays to 0. Scan the Save barcode from the Programming Chart, beginning on
page 225.
Note: Intercharacter delays are not supported in USB serial emulation.
* Enable
Disable
1 2345
Intercharacter Delay
Prefix Scanned Data Suffix
Intercharacter Delay