Honeywell Voyager 1602g - Safety Precautions for Lithium Batteries

Voyager 1602g User Guide 27
NCR Bioptic Aux Port Configuration
Scan the following Plug and Play code to program the scanner for an NCR bioptic
scanner auxiliary port configuration, then power cycle the host. This interface is
only appropriate for an Access Point.The following prefixes are programmed for
each symbology:
Wincor Nixdorf Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Wincor Nixdorf
terminal, then power cycle the host. This barcode sets the baud rate to 9600 bps
and the data format to 8 data bits, no parity, 1 stop bit. This interface is only
appropriate for an Access Point.
Symbology Prefix Symbology Prefix
UPC-A A Interleaved 2 of 5 b
UPC-E E0 Code 128 f
EAN-8 FF Code 32
Pharmaceutical
(PARAF)
a
EAN-13 F Code 39 a
NCR Bioptic Settings
Wincor Nixdorf Terminal Settings