Voyager 1602g User Guide 159
QR Code Append
This function allows the scanner to append the data from several QR Code bar-
codes together before transmitting them to the host computer. When the scanner
encounters an QR Code barcode with the append trigger character(s), it buffers the
number of QR Code barcodes determined by information encoded in those bar-
codes. Once the proper number of codes is reached, the data is output in the order
specified in the barcodes. There are 3 ways to scan appended QR Code:
One Scan: Pull the trigger one time and all appended QR Codes in the same image
are decoded.
Default = One Scan.
QR Code Page
QR Code pages define the mapping of character codes to characters. If the data
received does not display with the proper characters, it may be because the bar-
code being scanned was created using a code page that is different from the one
the host program is expecting. If this is the case, scan the barcode below, select the
code page with which the barcodes were created (see ISO 2022/ISO 646 Character
Replacements on page 220), and scan the value and the Save barcode from the
Programming Chart, beginning on page 225. The data characters should then
appear properly.
To Next Page
Loading...
