SCSI and I/O 8-15
3B 02 Tape Position Error at End of Medium 4
3B 08 Reposition Error 4
3B 0D Medium Destination Element Full 2
3B 0E Medium Source Element Empty 2
3D 00 Invalid bits in IDENTIFY message
3E 00 Invalid Microcode 3
3E 00 Logical Unit has not Self Configured Yet 2
3F 00 Target operating conditions have changed
3F 01 Microcode has changed
3F 02 Changed Operating Definition 1
3F 03 INQUIRY data has changed
40 00 Diagnostic or RAM failure
40 01 DRAM Parity Error 1
40 XX Diagnostic Failure (XX = FRU) 2
40 80 Power on Diagnostic failure
40 80 Diagnostic Failure (Vendor Specific) 6
40 81 Diagnostic Failure on Memories 6
40 82 Diagnostic Failure on CD-ROM ECC Circuit 6
40 83 Diagnostic Failure on Gate-Array 6
40 84 Diagnostic Failure on Internal SCSI Controller 6
41 00 Data path diagnostic failure
42 00 Power-On diagnostic failure
43 00 Message Error
44 00 Internal Controller/Target Error
44 00 Internal Software failure 5
45 00 Select/Reselect failed
46 00 Unsuccessful Soft Reset
47 00 SCSI Interface parity error
48 00 Initiator detected error
49 00 Inappropriate/Illegal message
4A 00 Command Phase Error 2, 4
4B 00 Data Phase Error
4C 00 Microcode Programing Failed 3
4C 00 Logical Unit Failed Self-Configuration 6
4E 00 Overlapped commands attempted
50 00 Write Append Error 2, 4
50 01 Write Append Position Error (sense key 3) 4
50 01 Write append position error, or illegal position to format partition (sense key 3) 5
Table 8-10 Hardware Status Bytes 12 and 13
ASC ASCQ Description Notes
To Next Page
Loading...
