222
8. Enable the router to
exchange IPv4 unicast
routing information used for
RPF check with peers in the
specified peer group.
peer
group-name
enable
By default, the router cannot
exchange IPv4 unicast routing
information used for RPF check
with the peers in the group.
To configure an EBGP peer group by using Method 1 (IPv6 multicast address family):
1. Enter system view.
system-view
N/A
2. Enter BGP instance view.
bgp
as-number [
instance
instance-name ]
N/A
3. Create an EBGP peer group.
group
group-name
external
By default, no EBGP peer groups
exist.
4. Specify the AS number of the
group.
peer
group-name
as-number
as-number
By default, no AS number is
specified.
If a peer group contains peers,
you cannot remove or change its
AS number.
5. Add an IPv6 BGP peer into
the EBGP peer group.
peer
ipv6-address [ prefix-length ]
group
group-name [
as-number
as-number ]
By default, no peers exist in the
peer group.
The
as-number
as-number
option, if used, must specify the
same AS number as the
peer
group-name
as-number
as-number command.
6. (Optional.) Configure a
description for the peer
group.
peer
group-name
description
text
By default, no description is
configured for the peer group.
7. Create the BGP IPv6
multicast address family and
enter its view.
address-family ipv6 multicast
By default, no BGP IPv6 multicast
address family exists.
8. Enable the router to
exchange IPv6 unicast
routing information used for
RPF check with peers in the
specified peer group.
peer
group-name
enable
By default, the router cannot
exchange IPv6 unicast routing
information used for RPF check
with the peers in the group.
To configure an EBGP peer group by using Method 2 (IPv4 unicast address family):
1. Enter system view.
system-view
N/A
2. Enter BGP instance view or
BGP-VPN instance view.
• Enter BGP instance view:
bgp as-number [ instance
instance-name ]
• Enter BGP-VPN instance
view:
a. bgp as-number
[ instance
instance-name ]
b. ip vpn-instance
N/A
To Next Page
Loading...
Need help?
General