8. Remove the riser cage.
9. Install the riser board on the cage.
10. (Optional) Install the expansion card .
11. Install the riser cage.
12. Install the access panel .
13. Installing the server into the rack .
14. Connect all peripheral cables to the server.
15. Connect each power cord to the power source.
16. Connect each power cord to the server.
17. Power up the server .
ResultsResults
The installation is complete.
Storage controller optionsStorage controller options
The server supports the following storage controllers:
Intel VROC for HPE Gen11 (Intel VROC)—Provides enterprise-level hybrid RAID support for direct attached SATA and NVMe SSDs.
HPE MR type-o and type-p Gen11 controllers
HPE SR type-p Gen11 controllers
For more information on drive array and storage controller configuration, see Configuring storage controllers.
SubtopicsSubtopics
Preparing the server for storage controller installationPreparing the server for storage controller installation
Installing a type-o storage controllerInstalling a type-o storage controller
Installing a type-p storage controllerInstalling a type-p storage controller
To Next Page
Loading...
