HPE Smart Storage Hybrid CapacitorHPE Smart Storage Hybrid Capacitor
Installing an energy packInstalling an energy pack
HPEHPE Smart Storage Battery Smart Storage Battery
The HPE Smart Storage Battery supports both HPE SR and MR storage controllers.
A single 96 W battery can support up to 24 devices.
After the battery is installed, it might take up to two hours to charge. Controller features requiring backup power are not re-enabled until
the battery is capable of supporting the backup power.
This server supports the 96 W HPE Smart Storage Battery with the 260 mm cable.
HPEHPE Smart Storage Hybrid Capacitor Smart Storage Hybrid Capacitor
The HPE Smart Storage Hybrid Capacitor supports both HPE SR and MR storage controllers.
The capacitor pack can support up to two devices.
This server supports the HPE Smart Storage Hybrid Capacitor with the 260 mm cable.
Before installing the HPE Smart Storage Hybrid Capacitor, verify that the system BIOS meets the minimum firmware requirements to
support the capacitor pack.
IMPORTANT:IMPORTANT:
If the system BIOS or controller firmware is older than the minimum recommended firmware versions, the capacitor pack
will only support one device.
The capacitor pack is fully charged after the system boots.
SubtopicsSubtopics
Minimum firmware versionsMinimum firmware versions
Minimum firmware versionsMinimum firmware versions
ProductProduct Minimum firmware versionMinimum firmware version
Server system ROM 1.20
HPE MR type-o and type-p Gen11 controllers 52.22.3-4650
HPE SR900 series type-p Gen11 controllers 03.01.14.062
Installing an energy packInstalling an energy pack
PrerequisitesPrerequisites
Make sure that a compatible type-p storage controller is installed .
Make sure that you have the storage controller backup power cable that ships with the storage controller.
To Next Page
Loading...
