SubtopicsSubtopics
Remove the front bezelRemove the front bezel
Power down the serverPower down the server
Open the cable management armOpen the cable management arm
Extend the server out of the rackExtend the server out of the rack
Remove the server from the rackRemove the server from the rack
Remove the access panelRemove the access panel
Remove the air baffleRemove the air baffle
Remove the processor mezzanine trayRemove the processor mezzanine tray
Remove the fan cageRemove the fan cage
Remove the riser cageRemove the riser cage
Installing the riser cageInstalling the riser cage
Install the fan cageInstall the fan cage
Install the processor mezzanine trayInstall the processor mezzanine tray
Install the air baffleInstall the air baffle
Install the access panelInstall the access panel
Install the server into the rackInstall the server into the rack
Power up the serverPower up the server
Remove the front bezelRemove the front bezel
About this taskAbout this task
If you are using the iLO virtual power button to power the server on/off, you do not need to remove the front bezel. Remove the front bezel
only if you need to access the front panel components.
ProcedureProcedure
1. If installed, remove the Kensington security lock.
For more information, see the lock documentation.
To Next Page
Loading...
