HP ProLiant DL560 Gen11 - Installing the riser cage; Procedure

Installing the riser cageInstalling the riser cage
ProcedureProcedure
1. Install the riser cage.
a. Carefully press the riser down on its system board connector (callout 1).
Make sure that:
The riser cage is aligned with the rear chassis.
The riser board is firmly seated on the system board.
b. Simultaneously push and rotate the half-turn spring latch to 180° (callout 2).
c. Close the spring latch (callout 3).
HPE ProLiant DL560 Gen11 Server User Guide 59