d. In the navigation tree, click the Remote Console & Media link, and then launch a remote console.
5. Press the Power On/Standby button.
For remote management, use the iLO virtual power button.
6. Configure the initial server setup.
7. Set up the storage .
8. Set the server power supply requirements .
9. Deploy an OS or virtualization software.
10. After the OS is installed, update the drivers.
Adjusting the server power supply redundancy settingAdjusting the server power supply redundancy setting
PrerequisitesPrerequisites
To verify that the server is cabled properly for power redundancy, see Power supply redundancy.
To determine the power draw of the system and verify that the server will continue to operate redundantly in the default configuration,
use the HPE Power Advisor:
https://www.hpe.com/info/poweradvisor/onlinehttps://www.hpe.com/info/poweradvisor/online
ProcedureProcedure
1. To access the UEFI System Utilities, press F9 during POST.
2. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration (RBSU) > Advanced Options.
3. Select the appropriate redundancy configuration from the Power Supply Requirements menu, and then press Enter.
4. Press F10 to Save or F12 to Save and Exit.
Operational requirementsOperational requirements
When preparing the site and planning the installation for the HPE ProLiant DL560 Gen11 Server, be sure to observe the following general
operational requirements:
Space and airflow requirements
Temperature requirements
Power requirements
Electrical grounding requirements
For server-specific environmental requirements, see Environmental specifications .
SubtopicsSubtopics
Space and airflow requirementsSpace and airflow requirements
Temperature requirementsTemperature requirements
Power requirementsPower requirements
Electrical grounding requirementsElectrical grounding requirements
To Next Page
Loading...
