a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
7. Disconnect all peripheral cables from the server.
8. Remove the server from the rack .
9. Place the server on a flat, level work surface.
10. Remove the access panel .
11. Remove the secondary riser cage.
12. Remove the boot device screws and spools.
13. Remove the security cover from the boot device bracket.
Retain the screws for the boot device installation.
14. Install the boot device onto the bracket:
a. Slide the boot device onto the bracket (callout 1).
To Next Page
Loading...
