HP StorageWorks 8/20q Reference Guide

HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Simple Network Management Protocol Reference Guide 135
Mandatory
Return value
Returns a value (1–5) indicating number of configured trap clients
trapRegIpAddress (1.3.6.1.3.94.2.3.1.1)
The IP address of a client registered for traps
Syntax
IpAddress
Access
Read-only
Status
Mandatory
Return value
The IP addresses (as defined in the trap table) of where to send traps when they occur.
trapRegPort (1.3.6.1.3.94.2.3.1.2)
The UDP port to send traps to for this host. Normally this would be the standard trap port (162). This object
is an index and must be specified to create a row in this table.
Syntax
INTEGER (1..2147483647)
Access
Read-only
Status
Mandatory
Return value
The configured port number of where to send traps when they occur. The port number can be
configured in the switch SNMP setup parameters. The default is 162.
trapRegFilter (1.3.6.1.3.94.2.3.1.3)
Defines the trap severity filter for this trap host. The connUnit sends traps to this host that have a severity
level less than or equal to this value. The default value of this object is warning.
Syntax
FcEventSeverity
Access
Read-write
Status
Mandatory
Return value
A value indicating the trap severity level. See Table 28 for trap severity levels.
trapRegRowState (1.3.6.1.3.94.2.3.1.4)
Specifies the state of the row.
• rowDestroy
• READ: Can never happen.

HP StorageWorks 8/20q Specifications

General

Brand	HP
Model	StorageWorks 8/20q
Category	Switch
Language	English