HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Simple Network Management Protocol Reference Guide 77
Mandatory
Return value
The SymbolicName of Switch. The default for the SN6000 Fibre Channel Switch is SN6000 FC
Switch. The default for the 8/20q Fibre Channel Switch is 8/20q FC Switch.
connUnitInfo (1.3.6.1.3.94.1.6.1.21)
A display string containing information about this connectivity unit. This object value should be persistent
between boots.
Syntax
DisplayString
Access
Read-write
Status
Mandatory
Return value
Returns the ConfigDescription field for the switch. The default is Default Config.
connUnitControl (1.3.6.1.3.94.1.6.1.22)
This object is used to control the addressed connUnit. Cold Start and Warm Start are as defined in MIB-II
and are not meant to be a factory reset.
• resetConnUnitColdStart: the addressed unit performs a Cold Start reset.
• resetConnUnitWarmStart: the addressed unit performs a Warm Start reset.
• offlineConnUnit: the addressed unit puts itself into an implementation-dependent offline state. In
general, if a unit is in an offline state, it cannot be used to perform meaningful Fibre Channel work.
• onlineConnUnit: the addressed unit puts itself into an implementation-dependent online state. In
general, if a unit is in an online state, it is capable of performing meaningful Fibre Channel work.
Each implementation may chose not to allow any or all of these values on a SET.
Syntax
INTEGER {
unknown(1)
invalid(2)
resetConnUnitColdStart(3)
resetConnUnitWarmStart(4)
offlineConnUnit(5)
onlineConnUnit(6)
}
Access
Read-write
Status
Mandatory
Return value
To Next Page
Loading...
Need help?
General