HP StorageWorks 8/20q Reference Guide

94 Fibre Alliance MIB Objects
connUnitPortSpeed (1.3.6.1.3.94.1.10.1.15)
The speed of the port in kilobytes per second.
Syntax
INTEGER
Access
Read-only
Status
Mandatory
Return value
The operational speed, otherwise returns the administrative speed setting. If 1 Gb/s, returns 106,250.
If 2 Gb/s, returns 212,500. If 4 Gb/s, returns 425,000. If 8 Gb/s, returns 850,000. If 10 Gb/s,
returns 1062500. If 20 Gb/s, returns 2125000.
connUnitPortControl (1.3.6.1.3.94.1.10.1.16)
This object is used to control the addressed connUnit's port.
• resetConnUnitPort: If the addressed connUnit allows this operation to be performed to this port,
the addressed port performs a vendor-specific reset operation. Examples of these operations are the
Link Reset Protocols, the Loop Initialization Protocol, or a re-synchronization
occurring between the transceiver in the addressed port to the transceiver that the port is connected to.
• bypassConnUnitPort: If the addressed connUnit allows this operation to be performed to this
port, the addressed port performs a vendor-specific bypass operation. Examples of these operations
are transitioning from online to offline, a request (non-participating) command to the Loop Port state
machine, or the removal of the port from an arbitrated loop by a hub.
• unbypassConnUnitPort: If the addressed connUnit allows this operation to be performed to this
port, the addressed port performs a vendor-specific unbypass operation. Examples of these operations
are the Link Failure protocol, a request (participating) command to the Loop Port state machine, or
addition of the port to an arbitrated loop by a hub.
• offlineConnUnitPort: If the addressed connUnit allows this operation to be performed to this
port, the addressed port performs a vendor-specific offline operation. Examples of these operations are
disabling a port's transceiver, the Link Failure protocol, a request (non-participating) command to the
Loop Port state machine, or removal of the port from an arbitrated loop by a hub.
• onlineConnUnitPort: If the addressed connUnit allows this operation to be performed to this port,
the addressed port performs a vendor-specific online operation. Examples of these operations are
enabling a port's transceiver, the Link Failure protocol, a request (participating) command to the Loop
Port state machine, or the addition of the port from an arbitrated loop by a hub.
• resetConnUnitPortCounters: If the addressed connUnit allows this operation to be performed
to this port, the addressed port statistics table counters is set to zero (0).
Each implementation may choose not to allow any or all of these values on a SET. On a read, if you do
not support write, then returns invalid(2). Otherwise, a read returns the last control operation
attempted.
Syntax
INTEGER {
unknown(1)
invalid(2)
resetConnUnitPort(3)
bypassConnUnitPort(4)
unbypassConnUnitPort(5)
offlineConnUnitPort(6)
onlineConnUnitPort(7)

HP StorageWorks 8/20q Specifications

General

Brand	HP
Model	StorageWorks 8/20q
Category	Switch
Language	English