HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Simple Network Management Protocol Reference Guide 21
Configuring SNMPv3 users
The following code for configuring SNMPv3 users demonstrates the attributes that must be defined to
configure an SMPv3 user:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> snmpv3user add
A list of SNMPV3 user attributes with formatting and default values as applicable
will follow.
Enter a new value OR simply press the ENTER key where-ever allowed to accept the
default value.
If you wish to terminate this process before reaching the end of the list,
press "q" or "Q" and the ENTER OR "Ctrl-C" key to do so.
Username (8-32 chars) : testuser
Group (0=ReadOnly, 1=ReadWrite) [ReadOnly ] : 1
Authentication (True/False) [False ] : true
AuthType (1=MD5, 2=SHA) [MD5 ] : 1
AuthPhrase (8-32 chars) : ********
Confirm AuthPhrase : ********
Privacy (True/False) [False ] : true
PrivType (1=DES) [DES ] : 1
PrivPhrase (8-32 chars) : ********
Confirm PrivPhrase : ********
Do you want to save and activate this snmpv3user setup ? (y/n): [n] y
SNMPV3 user added and activated.
Configuring a switch using the Simple SAN Connection Manager
To configure an SN6000 or 8/20q Fibre Channel Switch using the HP StorageWorks Simple SAN
Connection Manager, use the Set Switch Admin Password, Set Switch IP Address, and Set Switch SNMP
Properties dialogs. For specific information, see the HP StorageWorks Simple SAN Connection Manager
User Guide.
Configuring a switch using QuickTools
To configure an SN6000 or 8/20q Fibre Channel Switch using QuickTools, see the SNMP Configuration
section and the SNMP v3 Security section in the HP StorageWorks SN6000 Fibre Channel Switch
QuickTools Switch Management User Guide or the HP StorageWorks 8/20q Fibre Channel Switch
QuickTools Switch Management User Guide.
Configuring a switch using Enterprise Fabric Management Suite
To configure an SN6000 or 8/20q Fibre Channel Switch using Enterprise Fabric Management Suite, see
the SNMP Configuration section and the SNMP v3 Security section in the HP StorageWorks 8/20q and
SN6000 Fibre Channel Switch Enterprise Fabric Management Suite User Guide.
To Next Page
Loading...
Need help?
General