HP StorageWorks 8/20q - Adding an inter-fabric route

20 Configuring a Switch
Trap4Community public
New Value (press ENTER to not specify value, 'q' to quit) :
Trap4Enabled (True / False) :
Trap4Address (hostname, IPv4, or IPv6 Address) :
Trap4Port (decimal value, 1-65535) :
Trap4Severity (select a severity level)
1=unknown 6=warning
2=emergency 7=notify
3=alert 8=info
4=critical 9=debug
5=error 10=mark :
Trap4Version (1 / 2) :
Trap4Community (string, max=32 chars) :
SNMP Trap 5 Configuration - may optionally use 'set setup snmp trap 5' command.
Current Values:
Trap5Enabled False
Trap5Address 0.0.0.0
Trap5Port 162
Trap5Severity warning
Trap5Version 2
Trap5Community public
New Value (press ENTER to not specify value, 'q' to quit) :
Trap5Enabled (True / False) :
Trap5Address (hostname, IPv4, or IPv6 Address) :
Trap5Port (decimal value, 1-65535) :
Trap5Severity (select a severity level)
1=unknown 6=warning
2=emergency 7=notify
3=alert 8=info
4=critical 9=debug
5=error 10=mark :
Trap5Version (1 / 2) :
Trap5Community (string, max=32 chars) :
Do you want to save and activate this snmp setup? (y/n): [n] y
SNMP setup saved and activated