HP StorageWorks P9000 - Disk Arrays User Manual

Table 46 Error codes (part code 5205) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WRetry the same operation. If nothing
changes, please contact HP Technical
Support.
Auto LUN does not support the volume(s).12085205
WRetry the same operation. If nothing
changes, please contact HP Technical
Support.
Auto LUN does not support the volume(s).12095205
WInstall the shared memory if it is possible.
If it is impossible to install the shared
memory, the plan cannot be set any
further.
See the section about the computational
methods of the number of movement
plans described in the Auto LUN User
Guide for the relation between the
number of plans that can be made and
the shared memory.
The shared memory to set a plan is
insufficient.
12105205
WRetry the same operation. If nothing
changes, please contact HP Technical
Support.
The number of volume pairs exceeds the
maximum.
12115205
WRetry the same operation. If nothing
changes, please contact HP Technical
Support.
The source volume(s) is not equipped.12125205
WRecover the blocked volume, then retry
the operation. Also, the system disk
cannot be used as P-VOL. Specify
another volume.
The command was rejected due to one
of the following reasons.
• The volume specified as a migration
source was blocked.
• The volume specified as a migration
source was used as a system disk.
12135205
WRetry the operation after the format is
completed.
The volume specified as a migration
source is being formatted.
12145205
WThe command device cannot be used for
Auto LUN. Specify another volume.
The volume specified as a migration
source is a command device.
12155205
WRetry the same operation. If nothing
changes, please contact HP Technical
Support.
The target volume(s) is not equipped.12165205
WRecover the blocked volume, then retry
the operation. Also, the system disk
cannot be used as P-VOL. Specify
another volume.
The command was rejected due to one
of the following reasons.
• The volume specified as a migration
target was blocked.
• The volume specified as a migration
target was used as a system disk.
12175205
WRetry the operation after the format is
completed.
The volume specified as a migration
target is being formatted.
12185205
WThe command device cannot be used for
Auto LUN. Specify another volume.
The volume specified as a migration
target is a command device.
12195205
WRetry the same operation. If nothing
changes, please contact HP Technical
Support.
The volume is not a reserved volume.12205205
Part code 5205 117

HP StorageWorks P9000 - Disk Arrays Specifications

General

Brand	HP
Model	StorageWorks P9000 - Disk Arrays
Category	Storage
Language	English