Table 50 Error codes (part code 6005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WSelect another volume.A volume cannot be used as an R-VOL
when:
• it is used by Compatible XRC.
• it is used by PPRC or Remote Copy.
• it is used by Concurrent Copy.
• it is in a reserved condition.
• it is used by Continuous Access
Journal or Continuous Access Journal
Z.
• it is used by Business Copy Z or
Compatible FlashCopy.
87456005
WSee the INSTALLATION SECTION and
OPENPLATFORM SECTION in the
maintenance manual to confirm whether
the device emulation type of the M-VOL
is supported by Remote Copy.
The device emulation type of the M-VOL
is not supported.
87466005
WThe version of the microcode on the
9900 storage system does not support
the specified function or operation.
Please contact HP Technical Support.
Current microcode version does not
support the specified operation.
87476005
WData migration cannot start because the
volume is online. Vary the path offline,
and retry.
Specified M-VOL may be in use by
HOST.
87486005
WCheck if the input number of R-VOL is
correct. If not, enter the correct R-VOL
number. If the number is correct, vary
the specified path offline.
Specified R-VOL is still online from
HOST.
87496005
WConfirm the RCU controller emulation
type.
Remote Copy is not supported under the
RCU controller emulation type.
87516005
EPlease contact HP Technical Support.An internal error occurred.87536005
WCheck the serial number or SSID of
MCU, then retry with correct parameter.
Invalid MCU serial number or MCU
SSID.
87546005
WCheck the serial number, SSID or CU
number of the RCU, and retry the
operation with correct parameters.
Check the connection LCP ports of the
RCU. Connect the path correctly, and
retry the operation
The serial number, SSID or CU number
of the RCU is invalid.
87556005
WCheck the storage system cache status
of the MCU from the host. If it is off, set
it on and retry. If it cannot be set on,
please contact HP Technical Support.
MCU disk array cache is not active.87566005
EThere is an invalid cache or shared
memory status on the MCU. Check the
status and recover the cache or shared
memory, then retry the operation.
One side of the Cache or shared
memory on the MCU is blocked.
87576005
EPlease contact HP Technical Support.Unexpected error on MCU.87586005
WPlease contact HP Technical Support.RCU Subsystem Cache status is not
active.
87596005
Part code 6005 139
To Next Page
Loading...
