Table 50 Error codes (part code 6005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WAdd/resume pair operation failed. The
specified volume or another volume in
the same group being changed to
simplex/suspend status in RCU. After a
few minutes, refresh and check the
Continuous Access Synchronous window.
If specified volume is in a permissible
status, retry the operation.
Please wait. Retry Add
Pair(Paircreate)/Resume Pair(Pairresync)
operation in a few minutes.
88096005
iCancel the preset suspension in the CT
group, then retry the operation.
Preset Suspension is effective in the CT
Group.
88176005
iCancel the preset suspension in the CT
group, then retry the operation.
Preset Suspension is effective in the CT
Group.
88186005
WSelect another volume.A volume cannot be used as an R-VOL
when:
• it is in an intervention-required
condition.
• it is in a protection condition.
• it is in unusable condition.
• it is a secondary volume of Business
Copy or a target volume of Business
Copy Z.
• it is a reserved volume of Business
Copy or Business Copy Z.
• it is a volume reserved by Auto LUN.
• it is used by Continuous Access
Journal Z.
88196005
WThe Continuous Access Synchronous
operation failed, because R-VOL has one
of the following conditions:
• The volume is blocked.
• The volume is under maintenance.
• The volume is copying data
(correction copy or drive copy).
• The volume is in the correction access
condition.
The specified R-VOL is not a permissible
condition of Remote Copy.
88206005
WVerify the configuration of the specified
R-VOL.
The specified R-VOL is not recognizable
from the connection port.
88216005
WCheck whether the volume is in a usable
condition. If the volume is usable, please
contact HP Technical Support.
An I/O Error occurred on the R-VOL, or
the R-VOL is in an unusable condition.
88226005
EPlease contact HP Technical Support.An internal error occurred.88266005
WRetry the operation in a few minutes.
If this problem persists, select the volumes
where the error occurred, execute the
Delete Pair (Pairsplit-S) command with
the Force option, then retry the
operation.
Please wait a few minutes and retry the
Add Pair(Paircreate)/Resume
Pair(Pairresync).
88276005
Part code 6005 143
To Next Page
Loading...
