HP StorageWorks P9000 - Disk Arrays

Table 50 Error codes (part code 6005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WTake the following actions:
Specify only one CU# for the same LCP
of the RCU.
Connect to the LCP that can access the
specified R-VOL.
The LCP of the RCU cannot access the
specified R-VOL.
88296005
WCheck the status of the specified M-VOL
(P-VOL) from HOST or SVP.
The specified M-VOL is already used as
a reserved volume of Auto LUN.
88306005
WCheck the status of the specified R-VOL
(S-VOL) from HOST or SVP.
The specified R-VOL is already used as
a reserved volume of Auto LUN.
88316005
WCheck the status of the specified M-VOL
(P-VOL), then retry the Add Pair
(Paircreate) / Resume Pair (Pairresync)
operation in a few minutes.
Please wait a few minutes and retry the
Add Pair (Paircreate) / Resume Pair
(Pairresync) operation.
88326005
WCheck the status of the specified R-VOL
(S-VOL), then retry the Add Pair
(Paircreate) / Resume Pair (Pairresync)
operation in a few minutes.
Please wait a few minutes and retry the
Add Pair (Paircreate) / Resume Pair
(Pairresync) operation.
88336005
WSee the license key and confirm the
licensed capacity of the volumes. To
create more pairs, purchase a license
key that allows you to use a larger
capacity.
The Add Pair (Paircreate) operation
failed because you tried to create volume
pairs which exceeded the licensed
capacity.
88346005
WSee the license key of the RCU side, and
confirm the licensed capacity of the
volumes. To create more pairs, purchase
a license key that allows you to use a
larger capacity.
The Add Pair (Paircreate) operation
failed because you tried to create volume
pairs which exceeded the licensed
capacity of the RCU side.
88356005
WCheck the pair status and retry.No additional volume pairs waiting for
copy.
88366005
EPlease contact HP Technical Support.An internal error occurred.88376005
WThe specified volume is not part of a
Continuous Access Synchronous pair.
Check the volume.
Specified volume is not part of a Remote
Copy pair.
88386005
WCheck the serial number, SSID, link
address and controller ID of the RCU,
and set the correct value. Then retry the
operation. If the same error occurs,
please contact HP Technical Support.
Invalid RCU serial number, SSID, Link
Address or Controller ID.
88396005
WSuspend mode is not valid for the R-VOL.
Check the volume, and retry.
Suspend(Pairsplit-r) operation is not valid
for R-VOL.
88406005
WRefresh the window, and check whether
the specified volume is a R-VOL.
The specified volume is not a R-VOL.88416005
WConfirm the R-VOL status.R-VOL status change failed after M-VOL
status change. Confirm R-VOL status.
88426005
144 Message (part code group 6nnn)