HP StorageWorks P9000 - Disk Arrays

Table 50 Error codes (part code 6005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WThe operation failed, because of one of
the following reasons:
• The specified volume is simplex.
• There is no duplex or duplex-pending
volume in the group.
• Either the specified volume or another
volume in the same group is
suspended.
Verify the volume status, and retry the
operation.
Suspend(Pairsplit-r) operation failed
because specified volume or other
volume in the same group is not in
permissible status.
88436005
WThe operation failed, because of one of
the following reasons:
• The specified volume or another
volume in the same group is deleting.
• The specified volume or another
volume in the same group is
suspending.
Wait for the change in status to be
completed, then retry the operation.
Suspend(Pairsplit-r) operation failed
because specified volume or other
volume in the same group is in status
transition.
88446005
iCancel the preset suspension in the CT
group, then retry the operation.
Preset Suspension is effective in the CT
Group.
88456005
EPlease contact HP Technical Support.An internal error occurred.88466005
EPlease contact HP Technical Support.An internal error occurred.88476005
WThe suspend pair (Pairsplit-r) operation
failed. A few minutes later, refresh the
window, confirm if the specified volumes
are in the permissible status, then retry
the operation.
Please wait a few minutes and retry the
Suspend Pair(Pairsplit-r) operation.
88486005
WThe specified volume is not part of a
Continuous Access Synchronous pair.
Check the volume.
Specified volume is not part of Remote
Copy pair (Not in Duplex(PAIR),
Pending(COPY), Suspend(PSUS) state).
88496005
WCheck the serial number, SSID, link
address and controller ID of the RCU,
and set the correct value. Then retry the
operation. If the same error occurs,
please contact HP Technical Support.
Invalid RCU serial number, SSID, Link
Address or Controller ID.
88506005
WRefresh the window, and check whether
the specified volume is a R-VOL.
The specified volume is not a R-VOL.88516005
WConfirm the R-VOL status.R-VOL status change failed after M-VOL
status change. Confirm R-VOL status.
88526005
WThe operation failed, because of one of
the following reasons:
• The specified volume is simplex.
• There is no duplex, duplex-pending,
or suspend volume in the group.
Verify the volume status, and retry the
operation.
Delete Pair(Pairsplit-S) operation failed
because M-VOL is in Simplex(SMPL)
status.
88546005
Part code 6005 145