Table 50 Error codes (part code 6005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck whether the specified LDKC
number or CU number is defined as
configuration information of the MCU.
Since the configuration definition of the
specified LDKC number or CU number
does not exist, the logical paths between
MCU and RCU cannot be established.
89326005
WCheck the configuration of the specified
R-VOL.
The Paircreate operation failed because
specified R-VOL is the NAS system
volume.
89346005
WCheck the microcode version of the RCU.The Paircreate operation failed. The
version of the specified RCU does not
support Remote Copy with the NAS
volume.
89366005
WCheck the LUN of the specified M-VOL
by using RAID Manager, and specify the
LUN with the value less than 1,024 for
the M-VOL.
The specified M-VOL cannot be used.89396005
WConfirm the status of the specified R-VOL.The operation failed because the
specified R-VOL was in a Read Only
status by Volume Retention.
89406005
WRefresh the window a few minutes later,
and check the status of the specified
volume and other volume(s) of the same
group in the RCU. If it is possible to
perform operations on the volume(s),
retry the operation.
The specified volume or other volume(s)
of the same group in the RCU is being
changed to Simplex/Suspend status.
Retry the operation a few minutes later.
89436005
WCheck the status of the specified R-VOL.The specified R-VOL is not available
according to the attribute of the R-VOL
changed by Data Retention.
89446005
WVerify whether the parameters of M-VOL,
e.g., CU number, port, GID and LUN,
are supported with the RCU microcode
program version or not.
Verify whether the SSID and CU number
of RCU and the parameters of R-VOL,
e.g., Port, GID and LUN, are correct or
not.
Verify whether or not two or more CU
numbers coexist in P-VOL and S-VOL, if
you create a pair by using a LUSE
volume.
Specify RCUs of CU Free when two or
more CU numbers coexist in P-VOL or
S-VOL.
And then, retry the operation with the
correct parameters.
At least one of the following is invalid:
• M-VOL parameters (CU number, Port,
GID, LUN)
• SSID or CU number of the RCU
• R-VOL parameters (Port, GID, LUN)
89456005
WRelease the setting of the external
volume, then retry the operation.
The external volume that is mapped to
an internal volume is connected to the
port.
89476005
WStop I/O operations, then retry.The specified port is receiving I/O
requests.
89486005
EPlease contact HP Technical Support.An internal error occurred.89496005
EPlease contact HP Technical Support.An internal error occurred.89506005
Part code 6005 149
To Next Page
Loading...
