Table 50 Error codes (part code 6005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the status of the specified R-VOL.The operation failed because the
specified R-VOL was used for XP Flex
Copy.
89736005
WCheck the status of the specified R-VOL.Failed to create a pair, because the
specified R-VOL is path-defined from the
iSCSI port.
89756005
WCheck the status of the specified M-VOL.A pair cannot be created, because the
specified M-VOL is an external volume.
89766005
WCheck the status of the specified R-VOL.A pair cannot be created, because the
specified R-VOL is an external volume.
89776005
WConfirm the licensed capacity Mainframe
Array Management on the RCU side. To
execute this operation, purchase a
license key that allows you to use a
larger capacity.
The operation failed because the
licensed capacity of Mainframe Array
Management on the RCU side was
exceeded.
89806005
WSpecify the volume that can be used to
create a pair, then retry the operation.
You cannot create a pair, because the
specified M-VOL is a command device.
89826005
WSpecify the volume that can be used to
create a pair, then retry the operation.
You cannot create a pair, because the
specified R-VOL is a command device.
89836005
EPlease contact HP Technical Support.You cannot create a new pair, because
the number of CT groups of
asynchronous pairs that you can register
in SLPR exceeds the limit.
89846005
iCheck the settings, then retry the
operation.
The coexistence of volumes that are in
the different CLPRs is not allowed within
one CT group.
89856005
WVerify that both MCU and RCU support
LUSE volumes that consist of volumes
from different CUs.
Cannot create a pair, because LUSE
volumes consisting of volumes from
different CUs are not supported by either
the MCU or the RCU.
89876005
WVerify that both MCU and RCU support
LUSE volumes consisting of volumes that
differ in capacity.
Cannot create a pair, because LUSE
volumes consisting of volumes that differ
in capacity are not supported by either
the MCU or the RCU.
89886005
WCheck the version of the microcode of
the storage system.
If the microcode of the storage system
supports the interface between
Compatible FlashCopy and M-VOL of
Continuous Access Synchronous Z, then
check the setting of "Difference
Management" of the specified volume.
If microcode version or the setting does
not match the above description, check
whether the specified volume belongs to
Sync Group from Business Continuity
Manager.
The specified M-VOL is a volume used
by Compatible FlashCopy.
The operation failed because of one of
the following reasons.
• The current microcode cannot use a
volume used by Compatible
FlashCopy as an M-VOL.
• "Cylinder" was set for the "Difference
Management" of the M-VOL.
• The M-VOL belonged to Sync Group.
89896005
WSpecify the volume that can be used to
create a pair, then retry the operation.
A pair cannot be created, because the
specified R-VOL is used for Compatible
FlashCopy.
89906005
150 Message (part code group 6nnn)
To Next Page
Loading...
