Table 52 Error codes (part code 6010) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WTo execute this operation, click [OK],
Otherwise, click [Cancel].
Data has been changed and the graph
has been displayed. If you continue this
operation, all the data and the graph
will become invalid. Are you sure you
want to continue this operation?
91216010
iTo output pair status into a snapshot file,
click [OK]. To cancel this operation, click
[Cancel].
Are you sure you want to export pair
status?
91226010
iTo continue the operation, click [OK]. To
cancel the operation, click [Cancel].
This process may take up to %d minutes.
Do you want to continue?
91246010
WTo stop the operation, click [OK]. To
continue the operation, click [Cancel].
Are you sure you want to cancel the
export?
91256010
WTo terminate the script, click [OK].
Otherwise, click [Cancel].
The script is running now. Are you sure
you want to terminate the script?
91266010
WTo close the graphs, click [OK].
Otherwise, click [Cancel].
Are you sure you want to close all active
graphs?
91276010
WClick [OK], then specify the correct
volume.
The specified volume was not found.91286010
iClick [OK] to continue processing.Recovered from the error that occurred
when copying started.
91296010
iFollow the instructions in the message.As a result of this operation, you will not
be able to re-start ERASE R-VOL
operation. To delete the pair forcibly,
please try again with 'Force' option.
91546010
iClick [OK].The history file has been updated. Select
the OK button to display the history logs
from the beginning.
91556010
iFollow the instructions in the message.WARNING: Destination volume of
specified volume pair may contain some
inconsistency, because volume copy is
not completed yet. Full volume
initialization is required before re-using
it.
93006010
iFollow the instructions in the message.WARNING: Through this operation,
M-VOL status will be changed to SMPL
status forcibly, but R-VOL status will not
be changed. If you do this operation,
please change the R-VOL status to SMPL
later.
93016010
WConfirm whether the command device
for Business Continuity Manager is
defined.
There are no valid volumes.93036010
WSet the port to Initiator before registering
RCU.
There are no initiator ports.93056010
WThere is no Remote Copy license. Set the
license.
The Remote Copy function is not installed
in this controller. You cannot create
pairs.
93066010
WSince the same volume where multiple
paths are defined was selected, the
overlapped one was eliminated. Click
[OK] and continue.
You specified the same volumes more
than once. The duplicate occurrences
were excluded.
93076010
Part code 6010 161
To Next Page
Loading...
Need help?
General