Table 52 Error codes (part code 6010) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WSince there were overlapped paths in
the added paths, the overlapped paths
were eliminated. Click [OK] and
continue.
You set the same path more than once.
The duplicate paths are excluded.
93086010
WSince all the added paths overlapped,
the operation of adding paths cannot be
executed. Click [OK] and continue.
All paths which you set have already
been registered. This operation will
terminate because there is no path which
can be added.
93096010
WSince there were overlapped SSIDs in
the added SSIDs, the overlapped SSIDs
were eliminated. Click [OK], and
continue.
You set the same SSID more than once.
Duplicate SSIDs are excluded.
93106010
WSince all the added SSIDs are
overlapped, the operation of adding
SSIDs cannot be executed. Click [OK],
and continue.
All SSIDs which you set have already
been registered. This operation will
terminate because there is no SSID which
can be added.
93116010
WFollow the instructions in the message.Through this operation, M-VOL status will
be changed to Simplex mode even if the
M-VOL is online to the host.
93166010
iFollow the instructions in the message.The destination volume of the specified
volume pair may contain some
inconsistency because volume copy is
not completed yet. Full volume
initialization is required before re-using
it.
93176010
iTo delete the pair, even though you
cannot re-execute the R-VOL deletion,
click [OK]. If not, click [Cancel].
As a result of this operation, you will not
be able to re-start ERASE R-VOL
operation.
93186010
WTry again after the script ends.The specified operation is prohibited
while the script is running.
93246010
iClick [OK].The script is terminated forcibly.93256010
iClick [Refresh] to update the history file.
If this problem persists, please contact
HP Technical Support.
The monitoring time is over, but the
history file is not fully updated yet.
93276010
iClick [OK], then continue the operation.This operation is not applied yet.93326010
iThe requested operation has started.
Click [OK] to close the dialog.
The requested operation has started.93376010
WCheck the specified values and retry the
operation.
The specified value exceeds the range.
Alternatively, the relationship between
the specified values is not appropriate.
93606010
WSelect "Add RCU" command, then
register a DKC path.
If you plan to create a pair with the
specified LUSE volumes, a DKC path is
required.
550356010
WFind the CUs that can be used by the
storage system specified by the
Controller ID.
The subsystem specified by Controller ID
is not available for the particular CU
selected from the tree.
552026010
WFind the ports that can be used by the
storage system specified by the
Controller ID, and set them as initiator
ports.
There are no initiator ports that can be
used by the subsystem specified by
Controller ID.
552036010
162 Message (part code group 6nnn)
To Next Page
Loading...
Need help?
General