EasyManua.ls Logo

HP StorageWorks P9000 - Disk Arrays

HP StorageWorks P9000 - Disk Arrays
316 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table 53 Error codes (part code 6505) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EPlease contact HP Technical Support.An unexpected error occurred in the
primary subsystem.
87586505
WCheck the SSB of the specified
secondary data volume. See the
OPENPLATFORM SECTION in the
maintenance manual to check whether
the device emulation type of the
secondary data volume is supported.
The secondary data volume is unusable,
or the emulation type of the secondary
data volume is not supported by
Continuous Access Journal or Continuous
Access Journal Z.
87646505
WClick [OK] to finish processing. Then
wait a few minutes and retry the
operation.
The cache in the primary subsystem is
automatically recovering.
87706505
WSelect another volume.The primary data volume is already used
by Compatible XRC.
87766505
ECheck the status of the cache and the
shared memory in the secondary storage
system.
Ensure that the cache and shared
memory is not blocked.
One side of the cache or the shared
memory is blocked in the secondary
storage system.
87786505
WCheck the port, GID, and LUN settings
in the secondary storage system.
The specified volume is not defined in
the secondary storage system.
87886505
WVary the path offline from the other host,
then retry the operation.
The specified primary data volume is
online from hosts.
87916505
WCheck the status of the primary data
volume from the host or the SVP.
The operation failed because the
specified primary data volume was used
by Business Copy or Business Copy Z
and satisfied one of the following
conditions:
The volume was a Business Copy
S-VOL in non-PSUS status.
The volume was a Business Copy Z
T-VOL in non-Split status.
The volume was a reserved volume.
The volume was in the Reverse Copy
status.
87956505
WCheck the status of the secondary data
volume from the host or the SVP.
The operation failed because the
specified secondary data volume was
one of the following:
An S-VOL or reserved volume of
Business Copy
A T-VOL or reserved volume of
Business Copy Z.
A T-VOL of Compatible FlashCopy.
A Business Copy volume in the
Reverse Copy status
A Business Copy Z volume in the
Reverse Copy status
87966505
170 Message (part code group 6nnn)

Table of Contents

Other manuals for HP StorageWorks P9000 - Disk Arrays

Related product manuals