HP StorageWorks P9000 - Disk Arrays

Table 53 Error codes (part code 6505) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WExtract the possible combination of
program products from the combinations
of program products described in the
message. Check the status of the
secondary data volume from the window
of the program product. To use the Thin
Provisioning volume as a secondary data
volume, release the attribute of the
program product combined with the Thin
Provisioning volume, and then retry the
operation.
The operation failed because the
specified secondary data volume was
one of the following:
• An S-VOL of Business Copy.
• A T-VOL of Business Copy Z or
Compatible FlashCopy.
• A reserved volume of Business Copy
or Business Copy Z.
• A P-VOL of Business Copy in Swap
or Reverse Copy status.
• An S-VOL of Business Copy Z in
Swap or Reverse Copy status.
• A P-VOL of Business Copy used in
conjunction with Continuous Access
Synchronous.
• An S-VOL of Business Copy Z or
Compatible FlashCopy used in
conjunction with Continuous Access
Synchronous Z.
• A volume used by XP Flex Copy.
• A Thin Provisioning volume used as
a P-VOL of Business Copy.
• A Thin Provisioning volume and a
source volume of Auto LUN.
583536505
WCheck if the specified primary data
volume is used by any of the following
program products:
• Business Copy/Snapshot
• Continuous Access Synchronous
• Auto LUN
The specified primary data volume is
used by another program product.
583546505
WCheck whether the specified secondary
data volume is used by the following
program products.
• Business Copy/Snapshot
• Continuous Access Synchronous
• TrueCopy Asynchronous
• Auto LUN
The specified secondary data volume is
used by one of the following program
products.
• Business Copy/Snapshot
• Continuous Access Synchronous
• TrueCopy Asynchronous
• Auto LUN
583556505
WIf the problem persists despite retrying,
please contact HP Technical Support.
The disk subsystem is in internal process.
Please retry the operation.
584516505
WFrom the Compatible FlashCopy
window, check the status of the specified
primary data volume.
The Add Pair operation or the Resume
Pair operation failed because the
specified primary data volume was a
T-VOL of Compatible FlashCopy.
584566505
WSpecify a mirror ID other than 0, then
retry the operation.
Continuous Access Synchronous or
Continuous Access Synchronous Z is
using the specified primary data volume.
Specify a mirror ID other than 0 if you
use this volume to create a pair.
584576505
184 Message (part code group 6nnn)