HP StorageWorks P9000 - Disk Arrays

Table 55 Error codes (part code 6510) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WTo delete the specified path, click [OK].
Otherwise, click [Cancel].
Are you sure you want to delete the
paths of the specified subsystem?
590086510
iClick [OK]. Apply the Preview data to
the disk storage system, then retry the
operation.
Since the number of Preview data
exceeded the maximum, the excess data
were discarded. No more Preview data
can be stored.
590096510
iCheck the contents of the primary and
secondary volumes. If the contents match,
click [Yes]. Otherwise, click [No].
WARNING:
Initial copy mode "None" is selected for
some volume pair. Are you sure that the
primary data volume and the secondary
data volume of the pair are already
synchronized?
590106510
iTo output the file, click [Yes]. Otherwise,
click [No].
Are you sure you want to output the %s
file?
590116510
WTo overwrite the file, click [Yes].
Otherwise, click [No].
The specified file already exists. Do you
want to overwrite this file?
590136510
WCheck the DKC setting.The same DKC is specified more than
once. Check the DKC setting.
590266510
WTo continue the operation, click [OK]. To
cancel the operation, click [Cancel].
The current monitoring data will be
deleted if you change the setting of the
monitoring switch. If necessary, use the
Performance Monitor Export Tool to
export the monitoring data file.
The monitoring data saved at present
will be deleted.
590306510
iTo continue processing, click [OK]. To
stop processing, click [Cancel].
The monitoring data currently saved will
be deleted when you change the setting
of the monitoring switch. If necessary,
use the Export Tool to save the
monitoring data.
The monitoring data saved at present
will be deleted when the monitoring
switch is set to Enable the next time.
590316510
WPurchase a license for Continuous Access
Journal, then install it.
You cannot add journal volumes because
Continuous Access Journal is not
installed.
590396510
WAll journals are used by Continuous
Access Journal Z or Continuous Access
Journal. If possible, delete the journals
for Continuous Access Journal Z or
Continuous Access Journal, then start the
Continuous Access Journal Z window or
the Continuous Access Journal window.
There are no valid journals.590426510
WReduce the number of journal volumes
to be registered, or increase the number
of journal volumes to be deleted.
The number of journal volumes in some
journals exceeds the maximum.
Adjust the number of journal volumes.
590436510
208 Message (part code group 6nnn)