Table 56 Error codes (part code 6610) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the number of mirrors in the
journal. Then delete unused mirrors, or
register them in another journal.
Too many mirrors in the journal.550376610
WCheck the number of mirrors in the
journal group, then delete unused
mirrors.
Too many mirrors in the subsystem.550386610
WCheck the range setting. If you specify
"Mirror," select only one data volume
pair in the mirror.
You are specifying "Mirror" for the range
and trying to manipulate the same
mirror. Select only one data volume pair
in the mirror when you specify "Mirror"
for the range.
550396610
WCheck the specified controller ID.The specified controller ID cannot be
used.
552026610
WThe value of "Threshold of start Async
JNL" must equal or be less than the
"Threshold of start Sync JNL" value.
Some of the specified values are
incorrect. Two times the value of "M-JNL
Cache" plus the value of "R-JNL Cache"
must be equal to or less than 100. Or,
the value of "Threshold of start Async
JNL" must be equal to or less than the
value of "Threshold of start Sync JNL."
552076610
WSpecify the correct journal number.The specified journal number is incorrect.
Specify the correct journal number.
552086610
WSpecify normal deletion, or specify
"Mirror" as the range.
There are some pairs where "Mirror" is
not specified as the range in the pairs
specified to be deleted forcibly.
Specify "Mirror" as the range when you
want to delete pairs forcibly.
552296610
WTo delete pairs, click [Yes]. Otherwise,
click [No].
[Warning]
There are some pairs where "Group" is
not specified as the range in the pairs
specified to be deleted forcibly.
Other pairs in the same group may
suspend due to a failure by this
operation.
Are you sure you want to delete pairs?
556446610
WRegister a journal that has the same CLPR
number as the specified volume, then
retry the operation.
There is no journal registered that has
the same CLPR number as the specified
volume.
Register a journal that has the same CLPR
number as the specified volume, then
retry the operation.
565046610
WRegister secondary storage systems, then
retry the operation.
There are no secondary subsystems
available. Please register secondary
subsystems and then retry the operation.
565056610
WThere are no consistency groups
available. Create unused consistency
groups, then retry the operation.
There are no consistency groups
available. Please create unused
consistency groups and then retry the
operation.
565226610
WCheck the mirrors of the specified
volume.
No more mirrors can be created for the
specified volume.
565236610
214 Message (part code group 6nnn)
To Next Page
Loading...
Need help?
General