Table 59 Error codes (part code 7005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EPlease contact HP Technical Support.An SM failure was detected.85387005
EThere is insufficient shared memory in
DKC. Please contact HP Technical
Support.
There is insufficient shared memory to
create 4096 pairs.
85397005
EPlease contact HP Technical Support.There is sufficient shared memory to
create 4096 pairs, but initial subsystem
setup is required before creating pairs.
85407005
iClose the message box.There is sufficient shared memory to
create 4096 pairs, and the initial
subsystem setup is complete.
85417005
EPlease contact HP Technical Support.Failed to complete the initial shared
memory setup.
85427005
EPlease contact HP Technical Support.The shared memory size is different.85437005
i-16 Mbytes of shared memory is
available.
85447005
EPlease contact HP Technical Support.A power supply failure is detected.85457005
WRetry the operation with power ON.The command was rejected. The PS OFF
is in progress.
85467005
EPlease contact HP Technical Support.A data transfer failure is detected (CHA).85477005
EPlease contact HP Technical Support.A data transfer failure is detected (DKA).85487005
WYou cannot execute the operation for the
volume which is not implemented.
The P-VOL is not implemented.85497005
E
• Restore the blocked volume, then retry
the operation.
• The system disk cannot be specified
as a P-VOL. Specify another volume.
The command has been rejected,
because the specified P-VOL is blocked
or used as a system disk.
85507005
WWait until the volume is formatted, and
retry the operation.
The P-VOL is being formatted.85517005
WCheck the target volume.This volume cannot be specified as an
P-VOL because it is used as a command
device.
85527005
WYou cannot execute the operation for the
volume which is not implemented.
The S-VOL is not implemented.85537005
W
• Restore the blocked volume, then retry
the operation.
• The system disk cannot be specified
as an S-VOL. Specify another volume.
The command has been rejected,
because the specified S-VOL is blocked
or used as a system disk.
85547005
WWait until the volume is formatted, and
retry the operation.
The S-VOL is being formatted.85557005
WA volume that is not used as a command
device must be specified as an S-VOL.
This volume cannot be specified as an
S-VOL because it is used as a command
device.
85567005
WYou cannot execute the operation for the
volume which is not implemented.
The volume is not implemented.85577005
Part code 7005 225
To Next Page
Loading...
Need help?
General