HP StorageWorks P9000 - Disk Arrays

Table 59 Error codes (part code 7005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WYou cannot use the volume. Specify other
volume, and retry the operation.
The specified volume is for backup
servers only.
85807005
WCheck the contents, and retry.The specified volume is not for backup
servers only.
85817005
WWait a while, and retry the operation.The emulation type of the target volume
is being changed.
85827005
WSpecify a volume of the supported RAID
level.
The RAID level of the specified volume
is not supported.
85837005
WCheck the contents, and retry.No volume is defined as a reserved
volume.
85847005
WStop the operation of the Reserve volume
setting, or delete the Reserve volume.
The number of reserved volumes exceeds
the maximum.
85857005
WCheck the contents, and retry.The number of groups that can be set in
the same subsystem is invalid.
85867005
WCheck the contents, and retry.The number of pairs that can be set in
the same group is invalid.
85877005
WCheck the contents, and retry.The specified group number is not set.85887005
WCheck the contents, and retry.The specified group name is invalid.85897005
WCheck the contents, and retry.The group name and the number do not
match.
85907005
WCheck the contents, and retry.The specified pair is already set in
another group.
85917005
WCheck the capacity of the installed
license key. To create more pairs,
purchase a license key for larger
capacity.
The command was rejected, because the
licensed capacity was exceeded.
85927005
WRelease the Auto LUN setting.The P-VOL is a source volume for Auto
LUN.
85937005
WRelease the Auto LUN setting.The P-VOL is a target volume for Auto
LUN.
85947005
WRefresh, then retry the operation.The specified P-VOL does not exist.85957005
WRelease the specified volume’s reserve
attribute.
The specified volume is a reserved
volume.
85967005
WPairs cannot be created with the
specified P-VOL any more.
See the section "Volume pairs (P-VOLs
and S-VOLs)" in the HP StorageWorks
P9000 Business Copy User Guide for
the composition of pairs.
The command has been rejected,
because the number of pairs created with
the specified P-VOL has reached the
maximum.
85977005
WCheck the volume status.The specified volume is not a P-VOL.85987005
WSpecify other P-VOL, and retry the
operation. Or delete the pair of the
specified volume, then retry the
operation.
The specified volume is already a P-VOL.85997005
Part code 7005 227