Table 62 Error codes (part code 7105) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the specified volume number.Because the boot device is the T-VOL in
the DeletePair command, the flag does
not match.
86497105
WCheck the specified volume number.The boot device and the S-VOL do not
match in the AddPair, Resync, or
DeletePair command.
86507105
WCheck the contents, and retry.The SSID is invalid.86517105
WCheck the target volume number.The boot device is not an S-VOL nor
T-VOL.
86527105
WCheck the target volume number.Because the boot device is the S-VOL in
the DeletePair command, the flag does
not match.
86537105
WCheck the target volume number.The boot device and the T-VOL do not
match in the AddPair, Resync, or
DeletePair command.
86547105
WCheck the contents, and retry.An invalid secondary SSID is specified
for the AddPair or Resync command.
86557105
WCheck the contents, and retry.An invalid secondary SSID is specified
for the Delete Pair or Split Pair
command.
86567105
WPlease contact HP Technical Support.The Swap&Freeze option cannot be
specified, because the mode 80 is on.
86577105
WRelease the relationship to delete the
Compatible FlashCopy pair, or specify
another volume.
The command has been rejected,
because the specified S-VOL is being
used as the T-VOL of a Compatible
FlashCopy pair.
86967105
WRelease the relationship to delete the
Compatible FlashCopy pair, or specify
another volume.
The command has been rejected,
because the specified T-VOL is being
used as the volume of a Compatible
FlashCopy pair.
86977105
WRelease the relationship to delete the
Compatible FlashCopy pair, or specify
another volume.
The command has been rejected,
because the specified volume is being
used as the volume of a Compatible
FlashCopy pair.
86987105
WRelease the relationship to delete the
Compatible FlashCopy pair.
The Reverse Copy or Quick Restore
command has been rejected, because
the specified S-VOL is also being used
as the volume of a Compatible
FlashCopy pair.
86997105
WCorrect the specified CT Group and retry
the operation again.
The command was rejected because the
specified CT Group is already used.
89417105
WInstall the appropriate version of DKC
microcode.
The CT Group operation is not available
because the target DKC microcode
version does not support the CT Group
operation.
89427105
WReset the Split time of Consistency Group
from the mainframe host.
A pair status cannot be changed
because the Split time of Consistency
Group is set.
89467105
Part code 7105 249
To Next Page
Loading...
Need help?
General