Table 21 Error codes (part code 0605) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the setting of LDEV capacity.The total LDEV capacity defined in the
external volume exceeds the external
volume size.
665090605
WCheck the setting of emulation type.The specified emulation type cannot be
used.
665100605
WCheck the setting of CLPR.Specified CLPR is not mounted.665120605
WCheck the configuration and the setting
of external volume.
The target external volume has already
been mapped or set for mapping.
665170605
WCheck the setting of path configuration.The External Path configuration of the
target external volume is not
corresponding to that of another external
volume in the same External Path Group.
665180605
WCheck the mounted packages.Mainframe volume and intermediate
volume cannot be set because the
package for mainframe system is not
mounted.
665200605
WCheck the contents of the spreadsheet.Multiple operation tags are defined.665680605
WCheck the syntax of parameter.The syntax of the parameter is invalid.66675W0605
WSpecify the volume in an external storage
system.
The volume in the local storage system
cannot be operated.
666920605
WCheck the setting of target external
volume.
A correct parameter as a data transfer
volume is not set.
666930605
WCheck the setting of target external
volume.
A correct parameter as
RemoteCommandDevice is not set.
666940605
WSpecify the external port.Specified port is not external port.666950605
WCheck the value entered as PathMode.The value entered as PathMode is
outside the setting range.
666970605
WCheck the number of alternate Path
definitions.
The number of alternate Path definitions
that can be set to the external volume
has exceeded the maximum.
666980605
WCheck the number of LDEV definitions.The number of LDEV definitions that can
be set to the external volume has
exceeded the maximum.
666990605
WCheck the setting of External Path Group.The value of External Path Group is not
set within the available range.
667020605
WCheck the setting of Port number.It is not Port number that can be
specified.
667050605
WCheck the setting of LUN.It is not set within the range where LUN
can be used.
667100605
WCheck the setting of ExG.The value of ExG is not set within the
available range.
667130605
WCheck the setting of Attribute.Attribute is invalid.667150605
WCheck the setting of CLPR.It is not set within the range where CLPR
can be used.
667180605
WCheck the setting of emulation type.It is not emulation type that can be
specified.
667200605
46 Message (part code group 0nnn)
To Next Page
Need help?
General