Table 31 Error codes (part code 3005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCollect the information, then retry the
operation.
The frequency distribution data cannot
be obtained. There is no monitoring
information (VOL creation).
780293005
WCollect the information, then retry the
operation.
The frequency distribution data cannot
be obtained. There is no monitoring
information (HDEV SWAP or Cnt Ac-S
initial copy occurs).
780303005
WRecover the blocked Processor Blade,
then specify it.
The specified Processor Blade has been
blockaded.
780313005
WCheck the specified Processor Blade.The specified Processor Blade is not
mounted.
780323005
WClick [Refresh], then check the
configuration information again.
The specified POOL ID or the LDEV ID
does not exist.
780343005
WCheck the total capacity of Thin
Provisioning volumes, then retry the
operation.
The frequency distribution data cannot
be obtained. There is no monitoring
information (SM depletion).
780353005
WCheck the logical volume status, then
retry the operation.
The specified logical volume is already
in the normal status.
780363005
WRecover the pool.The pool is blocked.780373005
WCheck the configuration information.The specified POOL ID or the LDEV ID
is not for Smart Tiers use.
780383005
EPlease contact HP Technical Support.The DKC is set to the state of
suppression of pool shrinking.
780393005
EPlease contact HP Technical Support.The storage system is set to the state of
suppression of tier relocation starting.
780403005
WWait until the zero data pages are
discarded, or abort it.
The operation cannot be executed
because the specified pool is now in
zero data page discarding process.
780413005
WWait until the pool is shrunk or the tier
is relocated, or abort it.
The operation cannot be executed
because the pool where the Thin
Provisioning Volume belongs to is now
in pool shrinking or tier relocation
process.
780423005
EVerify the following items, and then retry
the operation.
• The threshold value of the pool.
• The pool status.
The operation cannot be executed
because the specified pool has
following problems.
• The pool usage exceeds the
threshold.
• The pool status is invalid.
780433005
EExecute any of the following actions,
then retry the operation.
If this problem persists, please contact
HP Technical Support.
• Restore the Pool-VOL to the normal
status.
• Reduce the I/O load of the V-VOL.
The operation cannot be executed
because the specified pool has one of
the following problems.
• The status of the specified Pool-VOL
is not normal.
• The I/O load of the V-VOL
associated with the specified pool
is high.
780443005
Part code 3005 87
To Next Page
Loading...
Need help?
General