To Next PageTo Next PageWhat to do if a Business Copy Z error message is displayed on HP StorageWorks P9000 - Disk Arrays Storage Remote Web Console?
Select the failed volume in the Preview List on the Pair Operation window, right-click to display the menu, and then click Error Detail.
Why are only Exit and Refresh menus effective when accessing the SVP from HP StorageWorks P9000 - Disk Arrays Storage Remote Web Console?
The SVP might not be ready, or another user is performing write processing. Wait and then refresh the window.
What to do if HP StorageWorks P9000 - Disk Arrays Storage disk array performs a self reboot?
If the disk array performs a self reboot because the disk array was busy or it logged a panic message, reboot the host.
Why can't I create logical volumes on my HP StorageWorks P9000 - Disk Arrays Storage?
If logical volumes cannot be created, verify that the volume capacity for OPEN-x volumes is not greater than the maximum capacity allowed. Verify that the capacity of the volume group is not less than the total capacity of the partitioned logical volume.
How to fix HP StorageWorks P9000 - Disk Arrays Storage physical volumes that cannot be created?
If physical volumes cannot be created, verify that the disk array logical devices are correctly formatted.
What to do if HP StorageWorks P9000 - Disk Arrays Storage file system is not mounted after rebooting?
If a file system is not mounted after rebooting, verify that the host was restarted correctly and that the file system attributes are correct.
How to get HP Storage logical devices recognized by the host?
If the logical devices are not recognized by the host, verify the following: * The READY indicator lights on the disk array are ON. * Fiber cables are correctly installed and firmly connected. * The TIDs/WWNs on each bus are unique. Do not install two devices with the same ID on the same bus. Recheck the buses for new devices. * The maximum number of LUSE devices per port has not been exceeded. * The disk array host mode is set correctly.
What to do if HP StorageWorks P9000 - Disk Arrays Storage host detects a parity error?
If the host detects a parity error, check the FCA and make sure it was installed properly. Reboot the host.
Why does my HP StorageWorks P9000 - Disk Arrays host not reboot after a hard shutdown?
If the host does not reboot properly after a hard shutdown, wait three minutes to allow the disk array's internal timeout process to purge queued commands. If the host restarts while the disk array is processing queued commands, the host may not reboot successfully.
General| Form Factor | Rack-mountable |
|---|---|
| Model | HP StorageWorks P9000 |
| Type | Disk Array |
| Category | Storage |
| Drive Type | SSD, SAS |
| RAID Levels | RAID 0, 1, 5, 6, 10 |
| Host Interface | Fibre Channel, FCoE, iSCSI |
| Connectivity | Fibre Channel, FCoE, iSCSI |
| Cache Memory | Up to 512 GB |
| Controllers | Dual controllers |
| Management Software | HP StorageWorks Command View |
| Redundancy | controllers, power supplies, and fans |
| Operating Humidity | 20 to 80% relative humidity, non-condensing |
Details error messages and recommended actions for part code 0001.
Details error messages and recommended actions for part code 0002.
Details error messages and recommended actions for part code 0003.
Details error messages and recommended actions for part code 1005.
Details error messages and recommended actions for part code 2005.
Details error messages and recommended actions for part code 3005.
