3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. Do one of the following:
a. Remove the air baffle.
b. Remove the midplane drive cage .
9. If installed, remove the cable guards .
10. Remove the midplane drive cage .
11. Disconnect the cables from the rear 4 LFF drive backplane.
12. Remove the rear 4 LFF drive backplane:
a. Remove the backplane screws (callout 1).
b. Remove the backplane from the drive cage (callout 2).
To Next Page
Loading...
