marked with the DP++ symbol—is not supported.
Display output modes:
If you connect two display devices to the VGA port and DisplayPort, the same image is shown on both devices—screen mirroring
mode.
The embedded video controller in the iLO 6 chipset does not support dual display or screen extension mode. To enable dual display
mode, install a compatible graphics card that supports this feature in the expansion slot.
Rear panel LEDsRear panel LEDs
ItemItem LEDLED StatusStatus DefinitionDefinition
1 Power supply Solid green The power supply is operating normally.
Off One or more of the following conditions exists:
Power is unavailable
Power supply failure
Power supply is in standby mode
Power supply error
The front I/O cable is disconnected.
2 iLO status Solid green Lined to network
Flashing green Network active
Off No network activity
3 iLO link Solid green Network link
Off No network link
4 UID Solid blue Activated
Flashing blue
1 flash per sec—Remote management or firmware upgrade in
progress
4 flashes per sec—iLO manual reboot sequence initiated
8 flashes per sec—iLO manual reboot sequence in progress
Off Deactivated
System board componentsSystem board components
To Next Page
Loading...
