b. Remove the midplane drive cage .
9. If installed, remove the cable guards .
10. Remove the rear 4 LFF drive cage .
11. Remove the riser cage.
12. Remove the expansion card .
13. Remove the riser board.
Retain all screws. These screws will be used to secure the new riser board spare.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the PCIe5 x16 low-profile riserRemoving and replacing the PCIe5 x16 low-profile riser
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
T-10 Torx screwdriver
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
To Next Page
Loading...
