HPE ProLiant DL385 Gen11 - Results; Removing and replacing the 12 E3.S drive backplane; Prerequisites; About this task

11. Remove the 2 SFF stacked drive backplane:
a. Remove the backplane screws (callout 1).
b. Remove the backplane from the drive cage (callout 2).
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the 12 Removing and replacing the 12 E3.SE3.S drive backplane drive backplane
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 180