ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the Removing and replacing the rackrack rails rails
PrerequisitesPrerequisites
If you are replacing the rack mounting rails from a threaded-hole rack, make sure that you have a T-25 Torx screwdriver available.
About this taskAbout this task
The illustrations used in this procedure show an icon on the upper right corner of the image. This icon indicates whether the action shown in
the image is for a round-hole, square-hole, or a threaded-hole rack.
Round-hole rack Square-hole rack Threaded-hole rack
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
To Next Page
Loading...
