10. Remove the midwall bracket.
11. Disconnect all cables from the drive backplane.
12. Remove the E3.S drive cage:
a. Remove the drive cage screws (callout 1).
Retain all screws for future use.
b. Remove the E3.S drive cage from the server (callout 2).
13. Remove the E3.S drive backplane:
a. Remove the backplane screws (callout 1).
Retain all screws. These screws will be used to install the new spare drive backplane.
b. Remove the backplane from the drive cage (callout 2).
ResultsResults
To replace the component, reverse the removal procedure.
To Next Page
Loading...
